Monthly Archives: April 2021

Broken Millefiori Bouquet Mosaic Coaster Before Grouting.

Broken Millefiori Mosaic Coaster

I made a mosaic bouquet coaster using our Broken Millefiori and Morjo 12mm Recycled Glass Tile. I used clear contact paper to lay out my design so that I could improvise without a pattern and make revisions as desired BEFORE glue is involved.

I wrapped the contact paper around the backer temporarily so that the design I laid out would be the exact same size as the backer.

I could have just traced the outline of the coaster on a piece of paper and taped the contact paper over the square outline.

Either way, the sticky side of the clear contact paper has to be showing because that is what is going to provide the little bit of stickiness required to keep the tiles from sliding around.

How Clear Contact Paper Is Used To Lay Up A Mosaic Design.
How Clear Contact Paper Is Used To Lay Up A Mosaic Design.

Design Without Glue

In the photograph below, the mosaic design is improvised on the sticky surface of contact paper.

Mosaic Laid Out On Contact Paper, Revised As Desired.
Mosaic Laid Out On Contact Paper, Revised As Desired.

Mosaic Mounting Tape

Mosaic Mounting Tape is clear and sticky like clear contact paper, but the adhesive is MUCH stronger (although still temporary/removable).

Once the design was completely laid out, Mosaic Mounting Tape was pressed onto the face of the mosaic and rubbed to ensure it is securely stuck to the tape.

Then the mosaic is lifted off the clear contact paper.

Mounting Tape Pressed Onto Mosaic, Then Lifted Off Contact Paper.
Mounting Tape Pressed Onto Mosaic, Then Lifted Off Contact Paper.

Apply Glue To Backer

Spread mosaic glue evenly onto the backer. Use a high-quality white PVA adhesive, such as the Weldbond we sell.

Make sure to follow the coaster’s instructions to avoid warping the backer with too much glue. It helps to seal the coaster with a minimal amount to glue a day or two before mosaicing.

Spread Mosaic Adhesive On The Backer
Spread Mosaic Adhesive On The Backer

Press Mosaic Into Adhesive

I prefer to turn the mosaic face down so that the backs of the tiles are showing, and then press the glue-covered backer down onto the mosaic.

Mosaic on Mounting Tape Pressed Onto Glue-Covered Backer.
Mosaic on Mounting Tape Pressed Onto Glue-Covered Backer.